Rockwell Automation 1794-OB16D FLEX I/O Diagnostic Modules User Manual - Manual (Page 69)

Publication 1794-UM061A-EN-P - July 2006
Configure Your Adapter and Digital Modules on a ControlNet Network 67
3. Configure the distributed I/O module. Depending on the distributed
I/O type, the configuration screens differ.
After you complete adding all Flex I/O modules to your project file, you
must download the project to your Logix5000 controller.
To: Do this:
Use the
module’s
default
configuration. Specify the general
information about the
module (name, comm
format, RPI, and others)
and click Finish.
Customize the
configuration. Specify the general
information about the
module (name, comm
format, RPI, and others).
Then use the Tabs to step
through subsequent
screens to configure such
parameters as filter times
and fault actions. If the
Open Module Properties is
checked, clicking OK will
automatically take you to
next tab.