Rockwell Automation 1771-QDC, D17716.5.85(Passport) MNL. PLASTIC MOLDING MODULE - Manual (Page 71)

Load Initial Configuration Values
Chapter 7
7-2
The following table lists command blocks and corresponding worksheets
for recording your initial values that you use to configure the QDC
module.
To configure the QDC module
with this configuration block
Use this
Worksheet
On
Page
Injection Configuration Command Block (INC) 7ĆA 7-3
Pack Configuration Command Block (PKC) 7ĆB
7-5
Hold Configuration Command Block (HDC) 7ĆC 7-7
Plastication Configuration Command Block (PLC) 7ĆD
7-9
Important: We omitted pre-and post-decompression blocks because you
do not use them when spanning valves in chapter 9. We discuss their
application in chapter 10.
Take a moment now to browse through the worksheets.
Notice that each worksheet contains two parts:
control words for selecting parameters by setting bits
a configuration block of data words for recording initial values
Also notice that many parameters repeat from one block to the next.
For example:
control bits for selecting an output
block parameters such as decel ramp rate during profile
Because of this, we describe how you determine an initial value once for
all configuration blocks that require it. Then you enter that parameter in all
applicable configuration blocks. That is why we grouped all worksheets
together, followed by all text.
Use These Worksheets