Rockwell Automation 1413-CAP-ME-PE Capacitor Bank Controller, Series C - Manual (Page 42)

42 Rockwell Automation Publication 1413-UM001D-EN-P - November 2010
Chapter 3 Configuration
PowerMonitor 1000 Meter
Configuration The table below lists the configuration parameters that must be set up for correct
operation of the capacitor bank controller.
For additional information regarding PowerMonitor 1000 meter configuration,
please refer to the PowerMonitor 1000 User Manual, publication
1408-UM001 .
Table 12 - PowerMonitor Meter Configuration Parameters
Parameter PowerMonitor 1 PowerMonitor 2 PowerMonitor 3 PowerMonitor 4
Wiring mode
PT (VT) primary voltage
PT (VT) secondary voltage
CT primary current
I4 primary current
IP address 192.168.254.64 192.168.254.65 (1) 192.168.254.66 (1) 192.168.254.67 (1)
Subnet mask 255.255.0.0
Default gateway address 128.1.1.1
(1) This IP Address is not the default configuration.
TIP When using multiple PowerMonitor meters, they all must be installed on
the same bus voltage level.