Rockwell Automation 7000 DPI Wireless Interface Module - Manual (Page 54)

4-6 Troubleshooting
If you encounter unexpected communications problems or are creating
an application that uses DF1 data, you can view the communications
statistics in the WIM. For DPI drives, Parameters 10 - [DF1 Packets
Sent] and 11 - [DF1 Packets Rcvd] store this data. For SCANport
drives, Parameters 07 - [DF1 Packets Sent] and 08 - [DF1 Packets
Rcvd] store this data.
To view and clear DF1 data, you must access the main menu in the WIM
firmware.
To view DF1 data
1. Access the parameters in the WIM using a configuration tool.
2. Scroll through the DF1 Parameters 10 and 11 (or DF1 Parameters 07
and 08 for SCANport drives), which contain DF1 data. For a
description of each parameter, refer to
Appendix B , WIM
Parameters .
To clear DF1 data
1. Access the parameters in the WIM using a configuration tool.
2. Set the value of Parameter 09 - [Clear DF1 Counts] (or Parameter
06 - [Clear DF1 Counts] for SCANport drives) to “1 = Clear
Counts,” and then press Enter to clear the DF1 data.
Viewing and Clearing DF1 Communication Statistics