Rockwell Automation 7000 DPI Wireless Interface Module - Manual (Page 42)

3-20 Configuring the WIM
7. After the driver is selected, click the Add New… button. The Add
New RSLinx Driver screen will appear. Create a name for the new
driver or use the default name, and click OK.
8. The Configure RS-232 DF1 Devices window ( Figure 3.34 ) appears.
Figure 3.34 Configure RS-232 DF1 Devices Window
Use the following settings:
Then click OK.
9. The Configure Drivers window ( Figure 3.35 ) will re-appear. Verify
that the status of the newly created driver is “Running.” Then click
Close.
Configuration Field Setting
Comm Port
Select the same COM port established by the Bluetooth
wireless technology enabled computer (noted in Step 4). For
this example, COM8 is used.
Device 1770-KF2/1785-KE/SCANport
Baud Rate Any setting
Station Number 00
Parity None
Error Checking Any setting
Stop Bits 1
Protocol Full Duplex