Rockwell Automation 7000 DPI Wireless Interface Module - Manual (Page 34)

3-12 Configuring the WIM
3. In the “Entire Bluetooth Neighborhood” window, double-click on the
device icon to which you want to establish wireless communication
(for this example, the “PowerFlex 70” icon). The “PowerFlex 70”
connection window (
Figure 3.21 ) will appear.
Figure 3.21 PowerFlex 70 Connection Window
4. In the “PowerFlex 70” connection window, double-click the “COM1
on PowerFlex…” icon to initiate the wireless communication
connection. A pop-up dialog box (
Figure 3.22 ) appears, indicating
the specific COM port to use for the connection (COM8 for this
example). Click OK.
Important: Always note the COM port shown in the dialog box
because this same specific port must be selected in the
DriveExplorer/DriveExplorer Lite Configure
Communication window (Step 6).
Figure 3.22 COM8 Dialog Box