Rockwell Automation 7000 DPI Wireless Interface Module - Manual (Page 3)

Summary of Changes
The information below summarizes the changes made to this manual
since its last release (July 2005):
The information below summarizes the changes made to this manual
since its last release (March 2005):
Description of Change Page(s)
In Chapter 3 in the “Using Pocket DriveExplorer for Pocket PC” section, added
the new subsection “Assigning a Name for the WIM.” 3-8
In Chapter 3 in the “Using DriveExplorer/DriveExplorer Lite” section, added the
new subsection “Assigning a Name for the WIM.” 3-14
In Chapter 3 in the “Using DriveExecutive” section, added the new subsection
“Assigning a Name for the WIM.” 3-23
Description of Change Page(s)
In Chapter 1 in the “Equipment Shipped with the WIM” section, added
categories and items for the 20-WIM-N4S and PowerFlex 70 NEMA 4X / 12
WIM. 1-3
In Chapter 3:
• Revised Sub step A in Step 10.
• Changed error checking setting in Step 8 from “Change to CRC” to “Any
setting.”
• Added subheading “To use the WIM when security mode is enable” and
related information.
• Added Important statement that the wireless connection will break after
resetting the WIM, and that the connection must be re-established.
3-7
3-20
3-25
3-26
In Chapter 4 in the “Viewing and Clearing Events” section, added the SCANport
Product Event List. 4-5
In Appendix C in the “Using Pocket DriveExplorer for Pocket PC” section,
combined Steps 8 and 9, and re-numbered subsequent steps. C-5