Talos Security IPC311-W 720P Manual - Manual (Page 22)

IP Camera User’s Manual
|
Fig 19
In this interface, users can set parameters like I/O alarm on/off, alarm schedule, linkage alarm
output, linkage output duration, linkage recording / capture, and sending E-mail when alarm has been
triggered, etc.
[I/O Type]: Close or open the I/O alarm detection.
[Alarm Schedule]: After enable this function, set the period of time for I/O alarm detection, four
periods allowed. Alarm schedule can be copied to the other d ate, select “Weekday” to the date or
everyday which set as the same settings.
[Output]: Enable or disable linkage alarm output.
[Linkage Output(s)]: Set the duration of linkage alarm output after being triggered (in seconds), the
range of alarm duration is 1~10s.
[Record]: When I/O alarm is triggered, it will record and store the video in the SD card on device. The
record files can be saved via E-mail sending or FTP uploading.
[Alarm Linkage(s)]: Set the duration of linkage recording after being triggered (in seconds), range
from: 5/10/30/60/120/300/600/900/1200/1800s.
[Capture]: When I/O alarm is triggered, it will snap pictures and store them in the SD card on device.
The captured pictures can be saved via E-mail sending or FTP uploading.