Talos Security IPC311-W 720P Manual - Manual (Page 13)

IP Camera User’s Manual
|
5.2 Network Configure
The interface of network parameters is shown in Fig 11:
Fig 11
[Device Port]: Default value is 5000 (users are recommended not to change it).
[Web Port]: Default value is 80 (users are recommended not to change it).
[RTSP Port]: Default value is 554 (users are recommended not to change it).
[ONVIF Port]: Default value is 554 (users are recommended not to change it).
[DHCP]: If DHCP function of the router is enabled, IP camera will automatically obtain IP address from
the router.
[IP address] : Set the camera’s IP address.
[Subnet mask]: Default value is 255.255.255.0 (users are recommended not to change it).
[Gateway] : Set the camera’s gateway IP. For example, when the device is connected to public
network via a router, the gateway IP is the router IP.
[Multicast address]: Multicast means the hosts of a group can receive all the data within this group.
Multicast address is the reserved class D address from 224.0.0.0-239.255.255.255, and some
address has special use (users are recommended not to change it).
[DNS Server]: The default server is the DNS address of Guangdong province. Users outside this area
please use DDNS function to set the DNS address as their local DNS address.
[Default gateway]: Set the default type of gateway. Two options: Wire and Wireless.