beautypg.com

SDC S6100 SERIES REVERSIBLE PANIC/FIRE EXIT User Manual

Page 9

background image

P:\INSTALLATION INST\Mechanical Hardware\INST-S6200.vsd Rev -

01-11 Page 5

STEP 3: INSTALL BOTTOM ROD AND BOTTOM STRIKE

1. Mount the bottom latch assembly into the mounting bracket (see figure 3).
2. Screw the threaded end of the bottom rod onto the bottom latch assembly (see figure 4).

3. Using screw supplied, attach and tighten the bottom rod to the chassis at the location
indicated by the arrow in figure 5.

NOTE: If the hole on the bottom shaft connector does not align with the mounting hole in

the chassis, adjust the length by turning the rod in or out of the latch assembly.

4. Install bottom strike into finished floor or threshold, and be sure to align center line of bottom
latch with the centerline of the bottom strike (see figure 6)

5. Depress and release push bar to confirm proper installation.
5-1 Make sure bottom latch can be retracted and flush with

the edge of the door when push bar is depressed.

5-2 Check bottom latch bolt has 19/32" (15mm) throw min.

when push bar is released.

Figure 3

Figure 4

Threaded end of

Bottom rod

Figure 6

1/4”

2-1/4”

7/8”

2-3/32”

L

C

Figure 5