beautypg.com

SDC S6100 SERIES REVERSIBLE PANIC/FIRE EXIT User Manual

Page 23

background image

P:\INSTALLATION INST\SWITCH KITS\INST-S6000-ATS.vsd REV -

04-12 Page 1

Any suggestions or comments to this instruction or

product are welcome. Please contact us through

our website or email [email protected]

INSTALLATION INSTRUCTIONS

S6000-ATS ANTI-TAMPER SWITCH KIT

Electrical Specifications:

WHT = COM

YEL = N/O

ORG = N/C

5AMPS @ 250V

Resistive

801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]

Insert Anti-Tamper Switch

where shown.

Insert the S6000-ATS Assy. into the device. Slide the End Cap over the

End Cap Bracket. Position the S6000-ATS Assy so the switch arm

makes contact and is activated by the inside surface of the End Cap.

Hold the S6000-ATS Assy. in place as you slide out the End Cap.

Tighten the set screws on the S6000-ATS to lock it in place.

Once S6000-ATS Switch Assembly is properly located, wire

the switch and re-install the Device Cover and End Cap.

END CAP

Switch Arm

Remove

Device Cover

and End Cap.

DEVICE

COVER

END CAP

END CAP

BRACKET