beautypg.com

SDC LR100MBSK ELECTRIC LATCH RETRACTION KIT Q1100, QF1100 User Manual

Step 1, Step 2

background image

INSTALLATION INSTRUCTIONS LR100MBSK

ELECTRIC LATCH RETRACTION KIT

MODELS: Q1100 & QF1100

P:\INSTALLATION INST\SWITCH KITS\INST-LR100MBSK.vsd REV -

05-14 Page 1

Any suggestions or comments to this instruction or

product are welcome. Please contact us through

our website or email [email protected]

Step 1

Attach the shorter end of link to
the clevis of the Electric Latch
Retraction assembly, then slide
the assembly into the device and
attach the larger open end of the
linkage to the rod inside at the
bottom of the Push Bar.

Step 2

Carefully slide the assembly
back out until the linkage JUST
makes contact with the latch
retraction rod. Tighten set
screws.

ELECTRICAL DATA

24VDC @ 700/200mA

RED (+)

BLK (-)

PATENT PENDING

801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]

SET

SCREWS

TIGHTEN SET

SCREWS TO

LOCK DEVICE

IN POSITION

When retrofitting to existing vertical rod

devices, adjustment of the rods is required for

proper operation of the Electric Latch Retractor.

Once the unit is properly installed, energize it

so the push pad is dogged down, then

reconnect the vertical rods to the device and

make the proper adjustments.