SDC LR100FRK FALCON IR SERIES ELECTRIC LATCH RETRACTION KIT F-25-R, F-25-V, F-25-C - Manual

P:\INSTALLATION INST\SWITCH KITS\INST-LR100FRK.vsd REV A 11-12 Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email [email protected]
INSTALLATION INSTRUCTIONS
ELECTRIC LATCH RETRACTION KIT
LR100FRK FALCON IR SERIES
MODELS: 24-R, 24-V, 24-C, F-24-R, F-24-V, F-24-C,
25-R, 25-V, 25-C, F-25-R, F-25-V & F-25-C
801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]
After removing the Falcon IR Exit Device from the door, detach the head and slide the Push Bar
assembly out of the extrusion. Attach the LR100FRK ELR unit to the Push Bar Assembly using
the existing holes in the base and the supplied screws where shown.
ELECTRICAL DATA
24VDC @ 500/180mA
RED (+) BLK (-)
PATENT PENDING
Make sure the linkage at the end
of the ELR unit engages the shaft
on the Exit Device as shown.
Carefully slide the Push
Bar Assembly with
attached ELR unit back
into the extrusion and
re-attach the head.
Test the unit before re-
installing on the door.
LR100FRK
Supplied
screws
When retrofitting to existing
vertical rod devices, adjustment of
the rods are required for proper
assembly of the LR100FRK Kit.
Please see the SDC website
(www.sdcsecurity.com) for
installation tips and photographs
of installing.