SDC LRVD1R PUSH PAD (REQUEST-TO-EXIT) SWITCH KIT VON DUPRIN 98/99-33 SERIES - Manual

P:\INSTALLATION INST\SWITCH KITS\INST-LRVD1R.vsd REV C 06-12 Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email [email protected]
LRVD1R
INSTALLATION INSTRUCTIONS
PUSH PAD (REQUEST-TO-EXIT) SWITCH KIT
VON DUPRIN 98/99-33 SERIES
Insert switch assembly into the extrusion with the back of the angle bracket against the inside
wall of the extrusion. Slide the switch assembly toward the device head until it‘s just in front of
the push bar without making contact. Locate and secure REX assembly as illustrated.
Applications
Access Control REX: Provides an authorized request-
to-exit signal to activate an access control REX input,
shunting the access control alarm output.
Magnetic Lock REX: Releases lock for uninhibited
egress when wired in series to lock power, or used to
activate a time delay trigger input to release lock for
egress.
Exit Alarm: May be used to activate an external alarm
horn located adjacent to the opening.
Remote Annunciation: Indicates door use when
connected to a remote annunciator,
RED = N/C
GRN = N/O
WHT = COM
BLK = NOT USED
3AMP @ 125VAC
RESISTIVE
REX SWITCH
ASSEMBLY
TIGHTEN DOWN SCREW
801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]