SDC LR100ARK ADAMS RITE ELECTRIC LATCH RETRACTION DEVICE KIT RIM EXIT DEVICE 8800 User Manual
SDC For Home
P:\INSTALLATION INST\SWITCH KITS\INST-LR100ARK-MORTISE_RIM.vsd REV A 11-13 Page 1
INSTALLATION INSTRUCTIONS LR100ARK
ADAMS RITE ELECTRIC LATCH RETRACTION DEVICE KIT
RIM EXIT DEVICE
MODELS: 3700, 8700 & 8800
801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email [email protected]
ELECTRICAL DATA
24VDC @ 500/180mA
RED (+) BLK (-)
PATENT PENDING
Assemble brackets
as shown for different
size Exit Devices.
Attach the Bracket assembly to
the existing Device linkage as
shown. Once the Bracket is in
place, bend out the tabs so the
Bracket assembly will slide easily,
without falling out or binding.
Install the ELR bracket
assembly into device
extrusion, over the Push
Bar support brackets.
Apply power to the ELR unit to make it draw the
sliding latch bracket back to the open position.
Secure in position by tightening the set screws in the
ELR assembly.
48"
36" or 42"
Slide ELR into back of
device and attach to
bracket assembly with
supplied screw.
Bend tabs out
Push Bar
support bracket
Remove End Cap