SDC LR100FAK FALCON(Dor-O-Matic) ELECTRIC LATCH RETRACTION KIT 1790 - Manual

P:\INSTALLATION INST\SWITCH KITS\INST-LR100FAK.vsd REV D 11-12 Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email [email protected]
INSTALLATION INSTRUCTIONS
ELECTRIC LATCH RETRACTION KIT
LR100FAK FALCON(Dor-O-Matic)
MODELS: 1690 & 1790
801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]
Remove Push Bar. Remove Dogging Assembly. Slide the ELR unit into the device base. Align
the first set of two holes over the two base unit holes and attach with the two #10-32 flat head
screws supplied. Attach the Linkage to the device as shown. Re-attach the Push Bar.
Dogging
Assembly
Linkage
DRILL .250 DIAMETER HOLE THROUGH
END CAP & UNIT BASE FOR WIRE RUN
Linkage
Align holes with Base and attach
with #10-32 flat head screws.
ELECTRICAL DATA
24VDC @ 500/180mA
RED (+) BLK (-)
PATENT PENDING
Push Bar
Spring Box
#10-32 Flat Head
Screws Supplied
END
CAP
When retrofitting to existing vertical rod devices, adjustment of the rods is required for proper operation of the
Electric Latch Retractor. Once the unit is properly installed, energize it so the push pad is dogged down,
then reconnect the vertical rods to the device and make the proper adjustments.