SDC LR100CRK CORBIN/RUSSWIN ELECTRIC LATCH RETRACTION DEVICE KIT ED5400 - Manual

INSTALLATION INSTRUCTIONS LR100CRK
CORBIN/RUSSWIN ELECTRIC LATCH RETRACTION DEVICE KIT
MODELS: ED4200, ED5200, ED5400 & ED5800
801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email [email protected]
ELECTRICAL DATA
24VDC @ 700/200mA
RED (+) BLK (-)
PATENT PENDING
P:\INSTALLATION INST\SWITCH KITS\INST-LR100CRK.vsd REV E 10-13 Page 1
Remove material between
these two holes to form a slot.
Loosen screws just
enough to insert the round
pin of the Strap Assy.
Strap Assembly
Attach the E.L.R. to
the Housing with the
supplied screws.
Attach the Strap Assy.
to the Motor Link.
Carefully remove the End Cap Cover,
End Cap, Cover, Cover Plug and
Housing Cover.
Cover Plug
Cover
Housing Cover
End Cap
Cover
End Cap
When using Narrow
style, extension
MUST be used
When retrofitting to existing
vertical rod devices,
adjustment of the rods is
required for proper operation
of the Electric Latch Retractor.
Once the unit is properly
installed, energize it so the
latch is dogged down, then
reconnect the vertical rods to
the device and make the
proper adjustments.