beautypg.com

SDC LRSG1R REQUEST-TO-EXIT ELR SWITCH KIT SARGENT User Manual

SDC For Home

background image

INSTALLATION INSTRUCTIONS LRSG1R

REQUEST-TO-EXIT ELR SWITCH KIT

SARGENT

P:\INSTALLATION INST\SWITCH KIT\INST-LRSG1R.vsd REV B 03-13 Page 1

Any suggestions or comments to this instruction or

product are welcome. Please contact us through

our website or email [email protected]

801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]

Attach the REX switch bracket to the ELR unit with the supplied screws. Attach ELR/REX assembly to
linkage (refer to ELR Installation Instructions). Insert REX switch assembly into device under the
linkage. Depress the Push Bar to raise the pivot arm. Slide the ELR and REX assembly under the
pivot arm and secure in place by attaching the ELR to the Device base with the supplied screw (refer
to ELR Installation Instructions). Release Push Bar and make sure the pivot arm is properly
depressing the switch arm.

Linkage

Push Bar
Pivot Arm

Secure unit in place with supplied screw.

COM WHITE

N/O

RED

N/C

GREEN

Attach REX
to ELR