SDC 295 Programmable Cabinet Lock - Manual

801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 • Fax: (805) 494-8861
www.sdcsecurity.com • E-mail: [email protected]
INSTALLATION INSTRUCTIONS
Model 295 – Programmable Cabinet Lock
Ideal for new installations, or a quick retrofit for keyed cam
locks
Suitable applications include: cabinets, cupboards, medical
carts, lockers, etc.
Keypad with 12 individual buttons (0-9, C, #)
Easily programmable codes:
1 Master Code, 1 Sub-master Code, & 30 User Codes
Configurable code length – 4 to 6 digits
Three Operation Modes available:
Multiple User mode, Code Free mode, &
Single Use mode (locker mode)
15,000 operations on 2 x AAA batteries (included)
Non-volatile memory
Battery failure override using a 9V battery and Master Code
Technical Information:
Door Thickness: up to 3/4"
Cam mounting: 3/4" square spindle
Hole required for spindle: 11/16" diameter
Batteries: 2 x AAA Alkaline (included)
Parts Included:
Cabinet Lock w/ key cylinder and spindle
Lock mounting screw & lock washer (x 2)
Cam, cam mounting screw & lock washer
Keys (x2)
Installation instructions & template
Replacing an existing cam lock with the Cabinet Lock:
1. Remove existing cam lock.
2. Place supplied template over the existing hole. Align the 11/16" spindle hole on the template with the hole left by cam lock. Mark
the upper & lower mounting holes.
3. Drill the two 3/16" mounting holes.
4. Cut the mounting screws to correct length. Measuring from beneath the bolt head, the length should be the cabinet thickness, plus
approx. 5/8".
5. Mount the cabinet lock to the door using the supplied lock washer & mounting screws.
6. From the inside of the door select and attach the appropriate cam using the supplied cam mounting screw & washer.
7. Before closing and locking the door, test the operation of the lock using the default Master and User Codes (See Basic
Operation on page 2).
8. It is recommended that the default Master and User Codes be changed at this time (See Quick Start Programming on page 2).
New installations:
1. Place the supplied template on door and mark the upper and lower 1/4" mounting holes and the 5/8" spindle hole.
NOTE: Before drilling fixing holes, verify that the position of the Cabinet Lock when fitted will allow enough clearance for the cam to
work.
2. Drill all three mounting holes.
3. Continue the installation from steps 4 though 8 above.
Features & Applications
Installation
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email [email protected]
P:\INSTALLATION INST\Access Controls\INST-295\INST-295.vsd REV C 10-13 Page 1