beautypg.com

SDC 350 NARROW LIINE EMLOCK User Manual

SDC For Home

background image

P:\INSTALLATION INST\Electromagnetic Locks\INST-350.vsd REV -

02-12 Page 1

Any suggestions or comments to this instruction or

product are welcome. Please contact us through

our website or email [email protected]

INSTALLATION INSTRUCTIONS

350 NARROW LIINE EMLOCK

Electrical Instructions:

Use properly fused U. L. Listed Power Supply

Do not install a diode in parallel with any magnetic lock. A diode
will cause a delay when releasing the door and residual magnetism
to occur.

Access controls and/or release contacts must be located in series
with the positive (+) power lead of the EmLock.

Any low voltage condition will cause erratic operation of the
optional board sensor.

Although SDC recommends the use of a Regulated DC power supply, a
transformer with an adjacent mounted full wave bridge rectifier
may be used. A significant voltage drop will occur when using a full wave
bridge rectifier.

Electrical Specifications:

Dual Voltage

12 or 24VDC

Power Consumption

540mA@12VDC
300mA@24VDC

DS Door Status Sensor SPDT, 250mA@30VDC
LS Lock Status Sensor SPDT, 2A@30VDC

Outswing

Quick Mount

Interlocking

Mounting Assembly

Mounting Screws

Armature

Interlocking

Mounting Plate

Frame

801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 •
www.sdcsecurity.com • E-mail: [email protected]

Retrofits Discontinued Locknetics 350+

Provides Superior Architectural Appearance

Supplied Mounting Hardware

PATENT NO. 5,376.910