Memmert INCO 246/246 med CO2 Incubators (Generation 2003) - Manual (Page 45)

45
Advanced functions
7. Advanced functions
7.1 Printer
(only for models with communication or premium modules)
Incubators with a communication or premium module are equipped with a parallel printer
port, as used in computers. Standard PCL3 compatible inkjet printers with a parallel port (e.g.
HP DeskJet 5550 or HP DeskJet 9xx) can be connected to the printer interface on the rear of
the appliance (see page ).
Make sure that a shielded interface cable is used. The shielding must be connected to the plug
casing.
The controller has an internal log memory (see page 62 ). The log data can be printed out in
this mode via the connected printer.
If a colour printer is connected, the various graphs are printed out in colour.
For a printout, the GLP header is also printed automatically, containing the following details:
► Date of printout
► Period of log
► Consecutive page numbers
► Serial numbers and appliance name
Running the printing function:
Select the PRINT operating mode with the
push-turn control, as described on page 30 . By
turning the push-turn control and holding down
the SET key, the following parameters can be selected and altered one after another, as
described in Chapter “ Basic operation “ on page 29 :
Querying the date of the first print page
Querying the date of the last print page
Starting graphical printout
Leaving the print menu and returning to the main menu
7.2 Basic appliance settings ( Setup)
(Setting options may vary depending on the appliance model)
In this operating mode, the basic settings for the
appliance can be made. The time, date, day and
year are set here, along with the settings for the
horn, the address allocation, the monitoring
units and the calibration.
PRINT SETUP
PRINT SETUP