Memmert INCO 246/246 med CO2 Incubators (Generation 2003) - Manual (Page 13)

13
Design and Function
2.4 Material
For the outer housing, MEMMERT uses stainless steel (W.St.No. 1.4016), and for the interior,
stainless steel (W.St.No. 1.4301), which stands out through its high stability, optimal hygienic
properties and corrosion-resistance towards many (but not all!) chemical compounds (caution
for example with chlorine compounds). The chamber load for the appliance must be carefully
checked with respect to chemical compatibility with the materials mentioned.
A material resistance table can be requested from the manufacturer.
2.5 Electrical equipment
► Operating voltage: See nameplate (page 18 ), 50/60 Hz
► Current consumption: See nameplate (page 18 )
► Protection class 1, i.e. operating insulation with safety earth terminal in accordance with
EN 61010
► Protection type IP 20 acc. to EN 60 529
► Interference-suppressed acc. to EN 55011 class B
► Appliance fuse: Fusible link 250 V/15 A quick-blow
► The temperature controller is protected with a miniature fuse 100 mA (200 mA at 115 V)
► For models with a humidity model the CO
2
controller is protected with a 6.3 A miniature
fuse
2.6 Connections
3
4
5
6
2
1
H
2
O
7 N2
In
Fig. 4 Connections on rear of appliance
1 Water connection (only for model with humidity module)
2 Mains lead
3 USB connection (only for models with communication or premium modules;
alternatively Ethernet, RS-232 or RS-485 connection) (details from page 58 )
4 Printer connection (only for models with communication or premium modules) (see page
45 )
5 CO
2
connection to main gas bottle
6 CO
2
connection to reserve gas bottle (only for models with CO
2
or premium modules)
7 N
2
connection (quick-release connector, only if equipped with O
2
module)