Memmert INCO 246/246 med CO2 Incubators (Generation 2003) - Manual (Page 30)

30
Operation and control
The control returns automatically to the main menu if the push-turn key or set key is
not operated for approx. 30 seconds.
Setting the temperature (Quick adjustment):
1. Hold down the SET key and set the desired temperature setpoint with the push-turn
control.
2. Release the SET key
The appliance flashes briefly, showing the temperature setpoint. Then the current temperature
appears on the display and the controller begins to move to the set temperature.
5.9 Operating modes
INCO incubators can be operated in three ways ( Fig. 19 ).
► Normal mode: The incubator runs in permanent operation at the temperature, humidity
and CO
2
values set on the operating panel. Operation in this mode is described from page
31 .
► Week time switch: The incubator runs at the set values only at certain times. Operation in
this mode is described from page 33 .
► Interface mode with PC/laptop (for models with communication or premium modules, see
from page 58 )
In addition, basic appliance settings can be made (SETUP, see page 45 ) and printouts can be
made if the appliance is equipped with the communication or premium module (PRINT, see
page 45 ).
PRINT SETUP
Normal
operation
(see Page 31 )
Week time
switch
(see Page 33 )
Printer
(see Page 45 )
Basic appliance
settings
(see Page 45 )
Fig. 19 Operating modes
5.10 Setting the operating mode
1. Hold SET key down for approx. three seconds, the selected operating mode
then begins to flash.
2. Select the desired operating mode (normal mode, week time switch, pro-
gramming mode, printer or basic appliance settings/setup by turning control
with SET key held down.
3. Release the SET key, and the selected operating mode is saved.
set
set
set