INFICON CMS5000 Monitoring System - Manual (Page 23)

3 - 3
IP
N 07
4-
50
8-
P1
C
CMS5000 Operating Manual
3.4 Mounting Instructions
CAUTION
Installation of the CMS5000 must be performed by an
INFICON authorized technician.
WARNING
The CMS5000 Monitoring System is heavy. Use proper
saftey procedures and PPE when mounting the unit.
NOTE: After the CMS5000 has been powered on, the system should only be
operated with the door closed to ensure stability of heated internal
components
The CMS5000 Monitoring System requires mounting as well as some minor
assembly. The four mounting brackets included in the ship kit need to be attached
to the four corners on the back of the unit. Position the bracket on the analytical
module by lining up the openings in the bracket and on the unit. Place the washer
over the lag bolt and using a socket wrench, screw in the lag bolt until tight (see
page 5 of the instructions included with the hardware). See
Figure 3-1 .
NOTE: The nuts included with the lag bolts are not needed to mount the brackets
to the unit.
Figure 3-1 Attaching the Mounting Brackets
Structural mounting hardware is not included. It is the responsibility of the user to
ensure that proper mounting hardware is used to support the weight of the
CMS5000, and (if the CMS5000 is to be used for continual online water monitoring)