INFICON CMS5000 Monitoring System - Manual (Page 208)

15 - 2
IP
N 07
4-
50
8-
P1
C
CMS5000 Operating Manual
Figure 15-1 Method Profile
Newly created methods start with a default set of Inlet States and a default
Temperature Profile, which can be modified as required by the application.
The Method Editor can be run in Wizard Mode, which moves through the method
creation in a logical sequence. Adjustments can be made using the Back and Next
buttons.
Figure 15-2 shows the Wizard Mode navigation buttons.
Figure 15-2 Method Editor Navigation Buttons
In non-Wizard mode, which is recommended only for experienced users, all pages
are available through a tabbed window. To change the Wizard mode settings, refer
to
section 11.2.4.3, Miscellaneous Tab, on page 11-11 for instructions. The
Method Editor must be reopened to initiate the selected mode. See Figure 15-3 .
Figure 15-3 System Properties Miscellaneous Page Wizard Setting
All method parameters on each page of the Method Editor are checked for
synchronization and correctness. The Method Editor will highlight all questionable
parameters and the Display Error Information button in yellow, when a
discrepancy occurs. See
Figure 15-4 .
NOTE: The Method Editor permits movement from page to page, even when
errors are present.
Figure 15-4 Error Information Button