ETC Unison Mosaic Show Control - Manual (Page 44)

44
LED
LED INSTALLATION
The Unison Mosaic LED Drivers (LED) are ancillary devices that provide direct LED control. As
such, they can not be used on their own but must have at least one Controller (LPC 1/2/4) or
Remote Input/Output Device (RIO 80/44/08) present to provide the DMX control data.
The units are designed to be permanently installed in a central control room/cupboard or DIN
consumer unit for remote deployment. The enclosure and mounting complies with DIN43880
and EN60715 (35/7.5 rail) respectively.
The units are 100% solid state and have been qualified to operate in a dry environment within a
temperature range of 0°C to 50°C (32°F to 122°F). Sealed IP65 rated consumer units are
available for outdoor use, please consult your ETC distributor or representative.
LED LAYOUT
The following drawing illustrates the layout of the Unison Mosaic LED, refer to the following
sections for details:
STATUS
LEDS
DMX INPUT & THRU
(NOT ISOLATED)
LED OUTPUTS (6)
DC INPUT
(SEE BELOW)
TEST & ADDRESS
WHEEL
LED VERSIONS
There are four versions of the LED available:
LED-V: 6 channel constant voltage LED driver (shown above), 12-24V DC input.
LED-C350: 6 channel constant 350mA current LED driver, 15-48V DC input.
LED-C500: 6 channel constant 500mA current LED driver, 15-36V DC input.
LED-C700: 6 channel constant 700mA current LED driver, 15-24V DC input.