beautypg.com

ETC Unison Mosaic Show Control User Manual

Page 42

background image

42

OPT

OPTO INSTALLATION

The Unison Mosaic 1+4 port DMX512 Repeater (OPTO) is designed to be permanently
installed in a central control room/cupboard or DIN consumer unit for remote deployment.
The enclosure and mounting complies with DIN43880 and EN60715 (35/7.5 rail) respectively.

The unit is 100% solid state and has been qualified to operate in a dry environment within a
temperature range of 0°C to 50°C (32°F to 122°F). Sealed IP65 rated consumer units are
available for outdoor use, please consult your ETC distributor or representative.

RDM LAYOUT

The following drawing illustrates the layout of the Unison Mosaic 1+4 port DMX512 Repeater,
refer to the following sections for details:

POWER SUPPLY

• DC power (9 to 48V)

nd

A limited power source approved to UL60950-1 2 Edition, CAN/CSA C22.2 No. 60950-

nd

1.07 2 Edition MUST be used, with an output voltage of 9 to 48V DC.

Such a power supply can be connected directly to the OPTO using the DC Input connector.
The pins on this connector are marked:

Positive input (9 to 48V DC)
Signal ground (0V)

Chassis ground (earth)

STATUS

LEDS

DMX INPUT & THRU

(OPTO-ISOLATED)

DMX OUTPUTS (4)

DC INPUT

(9-48V)