ETC Unison Mosaic Show Control User Manual
Page 19
19
X
POWER SUPPLY
The MSC X is mains powered via a fused, universal input power supply unit (PSU) compatible
with all worldwide mains supply standards; 100-250V 50/60Hz. The replacement fuse should be
a 250V rated 1A T (anti-surge) 20mm cartridge type only.
The MSC X will typically consume a maximum of 50-75W (MSC 200 @ 110-240V).
UK, EU and US mains IEC cables are provided.
GROUNDING
The MSC X must be correctly grounded to electrical safety earth at all times.
REALTIME CLOCK BATTERIES
The MSC X’s internal realtime clock is battery-backed to ensure operation when the unit is not
powered. The batteries should last for at least 10 years and are easily replaced when necessary,
replacement battery: Renata CR2032 Lithium Button Cell.
MEMORY CARD
The MSC X is shipped with a 4Gbyte Type I Compact Flash card which should be sufficient for
most projects since the MSC X’s data storage is extremely efficient, even with a multitude of
imported media files. However, a larger capacity card could of course be fitted if required.
As only the project’s programming data resides on the card, the card is also a convenient way to
backup data for archiving; the Designer project file for example.
Furthermore, in the event of MSC X hardware failure, simply moving the card into a
replacement unit is sufficient to get the project up and running again.
NOTE:
Power must not be disconnected when uploading project data nor during
bootloader/firmware updates to the MSC X as corruption of the data or
software may occur, perhaps even rendering the unit inoperable.
CAUTION:
For pluggable equipment, the socket outlet shall be installed near the
equipment and shall be easily accessible.
ATTENTION: En cas d'équipement enfichable, la prise doit être montée près de
l'équipement et doit offrir un accès facile.
CAUTION:
Risk of explosion if battery replaced by incorrect type. Dispose of used
batteries according to the manufacturer’s instructions.
ATTENTION: Il y a un danger d’explosion s’il y a un remplacement incorrect de batterie.
Mettre au rebut les batteries usages conformement aux instructions du
fabricant.