ETC Unison Mosaic Show Control - Manual (Page 37)

37
BPS
BPS LAYOUT
The following drawing illustrates the layout of a Unison Mosaic Button Panel Station (M108-6-
EU shown with overlay removed), refer to the following sections for details:
IR RECEIVER
RESET
ETHERNET
(PoE)
ADDRESS
WHEEL
STATUS
LEDS
POWER SUPPLY
• Power-over-Ethernet (PoE)
A standard (802.3af) Power-over-Ethernet switch should be used to provide both power
and a network connection to the BPS using a single cable. Alternatively, if a PoE switch is
not available, a PoE midspan injector could be used.
The BPS operates as a PoE Class 1 device (0.44>3.84W) and will typically consume 1.5W.
STATUS LEDS
The LEDs on the rear of the unit provide the following status information:
Pwr: Power - illuminates when the unit is correctly powered.
Act: Active - flashes slowly once the unit has successfully booted and is operational,
illuminates solidly once the BPS has connected to a Controller.
Net: Network - illuminates when the unit is sending or receiving Mosaic-related data.
Lnk: Link - illuminates once the unit has established an Ethernet link.
100: 100BASE-TX - illuminates when the Ethernet link is operating at 100Mbit/s.
NOTE: Power must not be disconnected during firmware updates to the BPS as
corruption of the software may occur, perhaps even rendering the unit
inoperable.