ETC Unison Mosaic Show Control - Manual (Page 30)

30
RIO
RIO INSTALLATION
The Unison Mosaic Remote Input/Output Devices (RIO) are ancillary devices that provide
additional input and output interfaces to a system. As such, they can not be used on their own
but must have at least one Controller present on an Ethernet network to function.
The units are designed to be permanently installed in a control room/cupboard or DIN
consumer unit. The enclosure and mounting complies with DIN43880 and EN60715 (35/7.5
rail) respectively.
The units are 100% solid state and have been qualified to operate in a dry environment within a
temperature range of 0°C to 50°C (32°F to 122°F). Sealed IP65 rated consumer units are
available for outdoor use, please consult your ETC distributor or representative.
RIO LAYOUT
The following drawing illustrates the layout of a Unison Mosaic Remote Input/Output Device,
refer to the following sections for details:
RIO VERSIONS
There are four versions of the RIO available:
RIO 80: 8 digital/analog inputs & RS232/485/DMX serial port.
RIO 44: 4 digital/analog inputs, 4 relay outputs & RS232/485/DMX serial port (shown above).
RIO 08: 8 relay outputs & RS232/485/DMX serial port.
RIO-A: Balanced stereo audio/timecode input & MIDI input/output ports.
ETHERNET
(PoE)
IO PORTS
IO PORTS
RESET
ADDRESS
WHEEL
STATUS
LEDS