ETC Unison Mosaic Show Control - Manual (Page 39)

39
BPS
To enter Learn Mode:
1. Enter by holding down the bottom two (or only two) buttons while pressing and releasing
reset.
• The buttons will display a clockwise chase sequence.
2. Release the two buttons.
• Each button will flash quickly (4Hz) if an IR code has been learnt, or slowly (1Hz) if not.
• No network communication will operate while in Learn Mode.
• Learn Mode will automatically exit after 60 seconds of inactivity.
To learn an IR Code:
1. Briefly press and release a single button which should learn the IR code.
• The button will start flashing rapidly (8Hz) and the other buttons will extinguish.
2. Within ten seconds, point the IR remote at the BPS and press and hold the desired key.
• The buttons will display a clockwise chase sequence when the IR code has been learnt.
3. Release the key on the IR remote.
• The button now will be flashing quickly (4Hz) to indicate that it has an IR code stored.
To erase an IR code:
1. Press and hold for three seconds the button which should erase its IR code.
• The buttons will display a clockwise chase sequence when the IR code has been erased.
2. Release the button.
• The button will now be flashing slowly (1Hz) to indicate that it has no IR code stored.
To test an IR code:
1. Point the IR remote at the BPS and press and hold the key to test.
• The button(s) that has learnt this code will illuminate solidly, all others will extinguish.
2. Release the key and test the others.
To exit Learn Mode:
1.
Press the reset button or wait for 60 seconds.
• The buttons will now revert to normal operation.
• Network communication will resume.
Note that the BPS does not have to be part of a networked Mosaic system to learn IR codes, all
that is required is PoE power and the donor IR remote control.