2N Lift8 v1.6.0 - Manual (Page 93)

93
2N TELEKOMUNIKACE a.s., www.2n.cz
®
longer than 2 s) on the audio unit keypad (green LED shining) to join in the call. Push
(for longer than 2 s) on the audio unit keypad (green LED flashing) to leave the
call without terminating it.
Before You Start
Product Completeness Check
Please check the package for completeness before starting 2N Lift8 Fireman
®
installation:
1 2N Lift8 Fireman
®
1 frame
1 double Torx 10 / Torx 20
Bushings (in package insert): 1
short manual1 2N Lift8 Fireman
®
mounting template
1 big two-hole sealed bushing with nut
1 replaceable one-hole sealing for big bushing for thick cables
1 big blind with nut
1 small bushing with nut
1 big bushing packing
2 small bushing packings
4 (5 × 90) mm screws
4 "intelligent" (8 × 50) mm plugs
Electrical Installation
Use the Torx 20 spanner included in the delivery to loosen the 4 screws and remove
the audio unit front cover. Find the board with electronics under the cover.
Caution
The Fireman calls has the highest priority and suspends all the other calls
except for the Fireman call set up in another shaft.
The Fireman call is set up to the cabin and machine audio units in one and
the same shaft.
You can join in the Fireman call from a machine room audio unit
configured as the intercom.