2N Lift8 v1.6.0 - Manual (Page 134)

134
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Explanations:
na = not applicable
ns = not served (ns* for machine room configured as the control centre: the
Fireman call is entered whenever the phone is answered)
q = put in queue
S = suspends ongoing activity
Automatic Check Call Answering
A control centre with a PC workplace with the server receives calls Lift8 2N
®
automatically as configured. Configure the server using the . Lift8 Control Panel 2N
®
Overview of Announcements
Announcement
(English)
Meaning of announcement
Caution, the call is
ending
Approaching call end announcement.
We are afraid the
call has to be
suspended
The call is interrupted by a requirement with higher priority.
Please wait Wait until the call is put through.
Communicator
number…is calling
Identification (if configured). In the future, In the future, user
recorded messages including the lift address, e.g., will be
played.
Check call Check call differentiation.
Rescue performed Confirmation of the end of emergency signalling.
Other s audio unit
waiting for
connection
Warning that a state of emergency has been activated in the
other lifts.
Call End (Outgoing/Incoming)
A call is terminated (line hang-up occurs) if any of the following cases happens:
The busy or continuous tone has been detected*) (call end on PBXs).
The timeout for call confirmation expired (see parameter 913 setting).
The configured maximum call time has been exceeded (parameter 912). 10
seconds before the expiry,
plays “Caution, the call is ending” for you to L8
extend the call with .
The or symbol has been received.
The time limit has expired during programming.
A higher-priority call request has arrived.