Upgrade, Licences – 2N Lift8 v1.6.0 User Manual

Page 163

163

2N TELEKOMUNIKACE a.s., www.2n.cz

Upgrade

The

menu helps you upgrade the

firmware via two menus: List of

Upgrade

applicable parameters and List of applicable voice menus. Click on the appropriate
name to select the FW version and voice menu type to be loaded to the

. Having

selected the items, click Upgrade to make the

load the new

2N Lift8 Service Tool

FW and voice menu into the

Licences

The

menu is used for adding licence files. The licences to be added to the

Licences

are only applicable in the UMTS/GSM module versions. The licence enables/disables the
network (provider) to which the device shall log in. Enter the IMSI code into the
licence: particularly the MCC and MNC to define the country and provider permitted for
the

. Enter a greater portion of the IMSI code to specify the SIM cards to be used in

one network. You can add up to 10 IMSI codes to the licence. Contact your 2N

Lift8

supplier or the manufacturer's Technical Support department (

) for the

[email protected]

licence file.

Having acquired the licence file, click Open from file and Load to device to open a file
browser with the licence location and click Confirm. The program will notify you of the
licence change and necessary device restart. Confirm your selection. Re-log in and
check the licence. The Allowed IMSI item will display the IMSI codes permitted by the
new licence.

Caution

Having upgraded the FW you will be notified of the

restart. After

confirmation, the restart will be made and the application will be
disconnected. Reconnection will not be possible until the system upgrades
the Audio Units and restarts. This process may take a few minutes in
extensive systems.

Caution

Any attempt to load licences for another serial number into the

will be

rejected.
If you fail to log in to a GSM/UMTS network, it is possible that the licence
permits a different IMSI range, which does not match the currently
inserted SIM card. This state is indicated as follows: the GSM/UMTS
module has a sufficiently strong signal, but the EXT. line LED is shining
red. Insert the correct SIM card or change the licence file.
The licence features only apply to the

s equipped with a GSM/UMTS

module.
There is no limitation as to the other PSTN/VoIP communication interfaces
even if the licence is added to the

If your

does not include any licence file, its function is not limited and

the inserted SIM card can log in to the provider's network, yet with some
limitations (roaming, e.g.).