Installation instruc tions – Poison Spyder JK FRONT CRUSHER FLARES User Manual

Page 9

INSTALLATION

INSTRUC

TIONS

Poison Spyder Customs • JK FRONT CRUSHER FLARES INSTALL

Page 9

FIGURE 33

27. At the rearward edge of the inner fender

liner, mark where the holes in the “L” brackets

are located behind the inner fender.

FIGURE 34

The inner fender liner is flexible plastic, and

you will be able to pull it away enough to take

your measurements. Mark the hole locations

then drill the three holes with a 1/4” bit.

FIGURE 35

28. Re-use three (3) of the OEM plastic retainer

clips that were removed at the beginning of

this procedure. Use one at each of the three

holes you just drilled. Insert the retainer into

the hole in the inner fender liner, and through

the corresponding hole in the “L” bracket.

Push firmly into place until the head of the

retainer is snug against the surface of the

inner fender liner.

FIGURE 36

29. Toward the front of the inner fender liner,

there is a small hole in the OEM tub frame

brace, behind the inner fender liner, as

shown in figure 37.

FIGURE 37

Transfer the location of this hole to the

surface of the inner fender liner, mark and

drill a corresponding hole with the 1/4” bit.

Install another of the OEM plastic retainer

clips at this location.

FIGURE 38

30. Repeat the procedure for the opposite side.