Poison Spyder JK BRAWLER MID FRONT BUMPER User Manual

Installation instruc tio ns, Jk brawler mid front bumper installation

INSTALLATION INSTRUC

TIO

The Poison Spyder Customs Brawler MID

Front Bumper is easy to install with the right

tools and good mechanical abilities. If you are

not confident in your mechanical skills, please

seek the help of a professional to perform the

installation. Please read through these entire

instructions before proceeding with installation.

PARTS LIST
Please check your packages immediately upon

arrival to ensure that everything listed is included,

and to check for damage during shipping. The

locknuts and washers are shipped attached to the

mounting studs inside the bumper. If anything is

missing or damaged, call Poison Spyder at (951)

849-5911 as soon as possible.

(1) JK Brawler MID Front Bumper
(8) 1/2-13 nylon insert lock nut
(8) 1/2 flat washer

TOOLS NEEDED

• Ratchet with 6” socket extension, 19mm

deep socket and 3/4” deep socket

• Torque wrench (ft./lbs.)
• 7/32” hex key
• Dead blow hammer or rubber mallet
• Phillips & flat head screwdrivers
• Removal tool for push-in retainer clips or

small pry bar

BEFORE YOU BEGIN
The JK Brawler MID Front Bumper and

associated components are shipped un-painted.

Before you paint or powder coat, perform the

entire installation of the product to ensure that

it fits without risking damage to your paint or

powder coat finish. Poison Spyder Customs is

not responsible for paint or powder coat costs

in the event you damage the finish during

installation, or that the parts are incorrect or

defective.
You will want to paint or powder-coat these

components prior to FINAL installation. If

painting them yourself, we recommend starting

with a quality etching primer and allowing

sufficient cure/dry time between coats and

before you apply color. Quality spray-can paints

are fine, however be sure to thoroughly paint all

of the inside corners and hard-to-reach areas

of the bumper. A little extra time and attention

to detail on your preparation and paint process

will pay off in longer-lasting good looks and rust

prevention.

INSTALLATION PROCEDURE
1. Park vehicle on a level surface and set the

emergency brake. You will want to wear eye

protection beyond this point.

2. Remove the plastic lower air dam. Use a

push-in retainer removal tool to pop out the

plastic push-in retainers along the front edge

and also underneath/behind the air dam

where it attaches to the crash bar. If you do

not have a push-in retainer tool, a flat-edge

screwdriver or small pry-bar may be used.

FIGURE 2

JK BRAWLER MID FRONT BUMPER

INSTALLATION