Poison Spyder ROCKBRAWLER HI-LIFT JACK MOUNT User Manual

Installation instruc tio ns, Rockbrawler hi-lift jack mount

INSTALLATION INSTRUC

TIO

ROCKBRAWLER HI-LIFT JACK MOUNT

The Poison Spyder Customs RockBrawler Hi-

Lift Jack Mount is designed to easily mount a Hi-

Lift jack to the spare tire rack on a Poison Spyder

RockBrawler Rear Bumper. It is easy to install

with the right tools and good mechanical abilities.

If you are not confident in your mechanical skills,

please seek the help of a professional to perform

the installation. Please read through these entire

instructions before proceeding with installation.

PARTS LIST

(1) RockBrawler Hi-Lift Jack Mount Plate
(4) Urethane Bushing
(2) 1/2-13 X 3” Carriage Bolt
(2) 1/2” Pushnut Bolt Retainer
(2) 1/2-13 Wing Nut
(2) 1/2-13 Nylon Insert Lock Nut
(4) 3/8-16 X 1” Gr8 Hex Head Cap Screw
(4) 3/8-16 Nylon Insert Lock Nut
(8) 3/8 Flat Washer

TOOLS NEEDED

• Primer, paint, cleaners (if painting)
• 9/16” end wrench, socket and ratchet
• 3/4” end wrench or socket and ratchet

(optional)

BEFORE YOU BEGIN
If your RockBrawler Hi-Lift Jack Mount came

as unpainted, bare steel, you will want to either

powder coat or paint the it prior to install. If

painting yourself, careful preparation will make a

big difference in the quality and longevity of your

paint job, even using “rattle can” aerosol paints.

Begin by thoroughly cleaning the bumper with

solvent or de-greaser, then make sure all residue

is removed. Even if you use cheap paint, try to

use a good quality primer. “Etching” primers are

best to use on bare, unpainted metal. Allow it to

properly dry before painting, and between paint

coats.
Note that you must already have both a

RockBrawler Rear Bumper with Tire Carrier and

a Hi-Lift jack. The Jack must have the lifting

mechanism at the bottom of its travel, with the

handle locked into place. The handle must

be secured by some mechanism such as the

urethane jack handle isolators that are available

at most 4X4 shops.

INSTALLATION PROCEDURE
1. Park the Jeep on a flat, level surface and

set the parking brake.

2. Remove the spare tire from the RockBrawler

Bumper Tire Carrier, if present.

3. Use the 3/8-16 Hex Head Cap Screws, Flat

Washers and Nylon Insert Lock Nuts to attach