Poison Spyder FRONT STINGER User Manual

Installation instruc tio ns, Front stinger installation

INSTALLATION INSTRUC

TIO

FRONT STINGER INSTALLATION

The Poison Spyder Customs Front Trail or

Comp Stinger is easy to install with the right

tools and good mechanical abilities. If you are

not confident in your mechanical skills, please

seek the help of a professional to perform the

installation. Please read through these entire

instructions before proceeding with installation.

PARTS LIST

(1) Front Stinger (Trail or Comp)

TOOLS NEEDED

• Torx T55 Socket
• Ratchet
• Torque Wrench

BEFORE YOU BEGIN
The Poison Spyder Customs Front Stinger comes

as un-painted, bare steel. You will want to either

powder coat or paint the bumper prior to install. If

painting yourself, careful preparation will make a

big difference in the quality and longevity of your

paint job, even using “rattle can” aerosol paints.

Begin by thoroughly cleaning the Stinger with

solvent or degreaser, then make sure all residue

is removed. Even if you use cheap paint, try to

use a good quality primer. “Etching” primers are

best to use on bare, un-painted metal. Allow it to

properly dry before paitning, and between paint

coats.

INSTALLATION PROCEDURE
1. Park the Jeep on a flat, level surface and

set the parking brake.

2. Remove existing front bumper. If it is still

the OEM bumper and hardware, there are

four bolts (two on the top and two on the

bottom that hold the bumper in place). These

will likely be Torx bolts, use a T55 torx bit.

3. Using the same hardware, install the

Stinger Bumper in place of the bumper that

was removed. Torque to OE specifications.

WARRANTY
Poison Spyder Customs™ warranties all of the

products we sell and distribute for one (1) year

from the date of sale. These products will be

free from defects in material and workmanship

under normal installation, and use. Due to the

intended use the powder coat finish is warranted

for ninety (90) days. The finish warranty will not

cover a product if it has been damaged in any

way. Warranty is limited to repair or replacement.

Poison Spyder Customs™ does not offer any

type of labor or shipping allowance and all

warranty claims are subject to inspection by

Poison Spyder Customs™.
At the discretion of Poison Spyder Customs™,

the products in question can be repaired or

replaced when found defective. Prior to any

replacement or repair, written authorization must

be obtained from Poison Spyder Customs™.

Failure to contact us prior to having warranty work

preformed will immediately void all applicable

warranties; and it is then the sole responsibility

of the customer to remit any payment incurred.
The warranty expressed above is the sole

warranty of Poison Spyder Customs™, and

any other expressed or implied warranties are

hereby specifically excluded and disclaimed.

HOLD HARMLESS AGREEMENT
1. In purchasing a Poison Spyder Customs

Product™ I release, waive, discharge and

covenant not to sue Poison Spyder Customs

officers, servants, agents, or employees

(hereinafter referred to as Releasees) from

any and all liability, claims, demands, actions

and causes of action whatsoever arising out

of or related to any loss, damage, or injury,

including death, that may be sustained by

me (or anyone else), any property belonging

to me (or anyone else), whether caused by

the negligence of the releasees or otherwise,

while working on, using or any activity related

to this product.

2. I am fully aware of risks and hazards connected

with the use of a this product and I elect to