Poison Spyder JK BRAWLER LITE FRONT SKID PLATE User Manual

Installation instruc tio ns, Jk brawler lite front skid plate installation

INSTALLATION INSTRUC

TIO

The Poison Spyder Customs JK Brawler Lite

Front Skid Plate is easy to install with the right

tools and good mechanical abilities. If you are

not confident in your mechanical skills, please

seek the help of a professional to perform the

installation. Please read through these entire

instructions before proceeding with installation.

PARTS LIST
Please check your packages immediately upon

arrival to ensure that everything listed is included,

and to check for damage during shipping. If

anything is missing or damaged, call Poison

Spyder at (951) 849-5911 as soon as possible.

(1) JK Brawler Lite Front Skid Plate
(13) 3/8-16 X 1 Gr8 Hex Head Cap Screw
(13) 3/8-16 Gr8 Nylon Insert Lock Nut
(9) 3/8 Gr8 Flat Washer
(4) 3/8 X 1 Fender Washer

TOOLS NEEDED

• Paint and paint supplies (if painting)
• 9/16” end wrenches (2)
• Abrasive cut-off wheel or other suitable

metal cutting tool

• 3/8” transfer punch and hammer
• Drill motor and 3/8” drill bit
• Touch-up paint or clear coat

BEFORE YOU BEGIN
The JK Brawler Lite Skid is shipped un-painted.

Before you paint or powder coat, perform the

entire installation of the product to ensure that

it fits without risking damage to your paint or

powder coat finish. Poison Spyder Customs is

not responsible for paint or powder coat costs

in the event you damage the finish during

installation, or that the parts are incorrect or

defective.
You will want to paint or powder-coat these

components prior to FINAL installation. If

painting them yourself, we recommend starting

with a quality etching primer and allowing

sufficient cure/dry time between coats and

before you apply color. Quality spray-can paints

are fine, however be sure to thoroughly paint all

of the inside corners and hard-to-reach areas

of the bumper. A little extra time and attention

to detail on your preparation and paint process

will pay off in longer-lasting good looks and rust

prevention.
The following installation instructions assume

that the customer already has a Brawler Lite or

front bumper, and that the OE bumper or the

Brawler Lite bumper has already been removed

from the Jeep. See the instructions that came

with your Brawler Lite front bumper for details on

that procedure.

INSTALLATION PROCEDURE
1. Park vehicle on a level surface and set the

emergency brake. You will want to wear eye

protection beyond this point. It is assumed

the stock bumper has already been removed,

and that the Brawler Lite bumper installation

is already in progress (The bumper shuold

not be mounted on to the Jeep yet).

Perform the following steps for installing the

Skid Plate, within the bumper installation

procedure where noted in the instructions for

the bumper.

2. Bolt the Skid Plate to the bottom of the

Brawler Lite Front Bumper, using the nine

(9) provided 3/8-16 X 1 Gr8 Hex Head Cap

Screws through the holes in the mounting

flange for each piece, fastened with the

provided 3/8 Gr8 Flat Washers and 3/8-16

Gr8 Nylon Insert Lock Nuts. These holes

will align when the two pieces are properly

JK BRAWLER LITE FRONT SKID PLATE

INSTALLATION