Poison Spyder JK FRONT ROCKBRAWLER BUMPER User Manual

Installation instruc tio ns, Jk front rockbrawler bumper install

INSTALLATION INSTRUC

TIO

Thank you for purchasing a Poison Spyder Front

RockBrawler Bumper for your Jeep JK. You

now own the ultimate off-road bumper, which

will give you many years of service. Installation

is fairly simple with the right tools and good

mechanical abilities. If you are not confident in

your mechanical skills, please seek the help of a

professional to perform the installation. Please

read through these entire instructions before

proceeding with installation.

PARTS LIST
Please check your packages immediately upon

arrival to ensure that everything listed is included,

and to check for damage during shipping. If

anything is missing or damaged, call Poison

Spyder at (951) 849-5911 as soon as possible.

(1) JK Front RockBrawler Bumper (A)
(1) Sub-Frame Bracket Retainer Plate (B)
(1) Sub-Frame Bracket (C)
(1) Removable Skid Plate (D)
(12) 3/8-16 X 1 SS flat head cap screw
(5) 3/8-16 nylon insert lock nut
(5) 3/8 flat washer
(11) 1/2-13 nylon insert lock nut
(11) 1/2 flat washer

TOOLS NEEDED

• Ratchet
• 6” socket extension
• 19mm deep socket
• 3/4” deep socket
• Torque wrench (ft./lbs.)
• 7/32” hex key
• Transfer punches: 5/16” & 15/32”
• Shop Hammer
• Dead blow hammer or rubber mallet
• Drill motor
• Drill bits: 1/4”, 3/8” & 11/16”
• Phillips head screwdriver
• Small flat head screwdriver
• Removal tool for

push-in retainer

clips (see Figure

1) or small pry bar

• Abrasive cut-off

wheel or other

suitable

metal

cutting tool

• Touch-up paint or clear coat

BEFORE YOU BEGIN
The JK Front RockBrawler bumper and

associated components are shipped un-painted.

You will want to paint or powder-coat these

components prior to installation. If painting them

FIGURE 1

JK FRONT ROCKBRAWLER BUMPER INSTALL