Hale FoamLogix 6.5 User Manual
Page 145
Troubles hooting
❑
145
FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
4. If there is no indication of water flow on the control unit display troubleshoot
the flow sensor.
5. If water flow is established, turn the Hale FoamLogix system ON to flow foam.
6. Observe foam pump discharge. If foam is NOT flowing troubleshoot the foam
pump.
7. Check accuracy of system using the calibration procedures and making
adjustments as required. (See Section 4.2, “User Calibration,” on page 111
for more information.)
❑
Do Not remove or alter any hydraulic or pneumatic connections, electrical devices,
etc.
❑
Do Not tamper with or disconnect safety features or modify protective guards
(such as covers or doors).
❑
Do Not add or remove structural parts. Doing so voids the warranty.
WARNING !
ANY OF THE ABOVE COULD AFFECT SYSTEM CAPACITY AND/OR SAFE
OPERATION OF THE SYSTEM AND IS A SERIOUS SAFETY VIOLATION
WHICH COULD CAUSE PERSONAL INJURY, COULD WEAKEN THE CON-
STRUCTION OF THE SYSTEM OR COULD AFFECT SAFE OPERATION OF
THE FOAMLOGIX PROPORTIONING SYSTEM.