Hale FoamLogix 6.5 - Manual (Page 131)

131 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
Ope ra tion
❑
5.9 SIMULATED FLOW MODE OPERATION
The Simulated Flow mode of the Hale FoamLogix system allows operation
of the foam pump without discharging water through a foam capable dis-
charge or when the flow sensor is not functioning. (See Figure 5-7: “Simu-
lated Flow Display Sequence,” on page 132.)
The simulated flow mode is used to drain the foam tank for:
❑ Cleaning
❑ Checking calibration of the feedback sensor
Read Total Foam Concen-
trate
Press i until LED below TOTAL FOAM
illuminates.
Reset Totalized Values While in TOTAL FLOW or TOTAL
FOAM, press and release
or .
End Foam Injection Press ON.
Operation Action Display
Figure 5-6: Normal Operation Summary Chart