Hale FoamLogix 6.5 - Manual (Page 120)

❑ Setup and Calibration
120 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
English to Metric Units
The FoamLogix Display offers both English and Metric readouts.
The Hale FoamLogix system is calibrated at the factory for ENGLISH - U.S.
measurement units (GPM, PSI, GALLONS, etc.).
To switch from English to Metric and back again,
1. Press and hold the i button. The display show PASS, then clears.
2. While continuing to hold the display button, enter the password ( ).
3. The display shows IN to indicate Metric units are selected.
Note: Switching back to English is accomplished by repeating Steps 1 through
3. The display shows EN to indicate English units.