Figure 5-8: dual tank selector operating positions – Hale FoamLogix 6.5 User Manual
Page 134
❑ Operation
134
FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
CAUTION !
UNLESS ENGAGED IN CLASS “B” FOAM OPERATIONS, THE HALE FOAM-
LOGIX ADT TOGGLE SWITCH OR HALE FOAMLOGIX MDT II SELECTOR
HANDLE MUST BE IN THE TANK “A” POSITION. IF THE TOGGLE SWITCH OR
SELECTOR HANDLE IS IN THE FLUSH POSITION WHEN THE FOAM PUMP IS
STARTED, THE FOAM PUMP RUNS FOR ONLY TWENTY (20) SECONDS,
THEN SHUTS DOWN.
Figure 5-8: Dual Tank Selector Operating Positions
Make sure the Hale FoamLogix is operating and foam solution is being dis-
charged. (See Figure 5-8: “Dual Tank Selector Operating Positions,” on
page 134.)
1.
Set the Hale ADT toggle to the desired TANK, or turn the Hale Foam-
Logix MDT II handle until the indicator points toward the desired TANK.