Hale FoamLogix 6.5 - Manual (Page 104)

❑ Start-up Check List
104 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
3.8 INSTALLATION AND DELIVERY CHECK LIST
After the Hale FoamLogix system is installed, use the following check list to
verify installation and ensure proper system setup when the apparatus is
delivered to the end user.
Installation
Date Initials
_______ _______ ❑ System properly installed. See Section 3.7 “Start Up Check
List” on page 101.
_______ _______
❑ Tank level sensor function verified. See Section 3.7 “Start Up
Check List” on page 101.
_______ _______
❑ Foam pump operation checked. See Section 3.7 “Start Up
Check List” on page 101.
_______ _______
❑ Foam tank and hoses drained of water. See Section 3.7 “Start
Up Check List” on page 101.
_______ _______
❑ Flow sensor function checked and calibrated. See Section 4.2
“User Calibration” on page 111.
Delivery
Date________ Initials
_______ _____ ❑ Foam tank filled with user specified foam concentrate. See
Section “Low Foam Tank Level Message” on page 126. Also
see heading “Appendix A: Foam Concentrate Compatibility” on
page 149.
_______ _______
❑ Foam pump priming checked. See Section 5.7 “Priming the
Foam Pump” on page 128.
_______ _______
❑ Flow sensor calibration verified with Pitot. See Section 4.2
“User Calibration” on page 111.
_______ _______
❑ Default simulated flow value set to end user specification.
See Section 4.2 “User Calibration” on page 111.
_______ _______
❑ Default foam concentrate injection rate set to end user specifi-
cation. See Section 4.2 “User Calibration” on page 111.
_______ _______ ❑ Foam concentrate feedback value verified and calibrated with
end user specified foam concentrate. See Section 4.2 “User
Calibration” on page 111.
_______ _______
❑ Proper Hale FoamLogix system operation demonstrated to
end user in accordance with manual procedures. See Section
5 “Operation” on page 121.
_______ _______
❑ End user trained in proper operation of Hale FoamLogix sys-
tem in accordance with manual procedures. See Section 4.2
“User Calibration” on page 111.
_______ _______
❑ Warranty registration card filled out by end user and mailed to
Hale Products Inc.
_______ _______
❑ Two copies of Installation and Operation manual provided to
end user.