Konica Minolta MAGICOLOR 2300 - Manual (Page 75)

Replacing Consumables 65
4
Secure the two caps onto the two holes by
turning them clockwise.
5
Dispose of the used waste toner bottle.
WARNING!
Dispose of the used waste toner bottle properly according to your local
regulations (do not dispose of it by burning).
Installing the New Waste Toner Bottle
1
Remove the new waste toner bottle from its carton.
2
Insert the bottom of the waste toner bottle
$
into its installation position in the printer.
3
Push the top of the waste toner bottle %
into position until it is firmly seated.
4
Close the printer’s front door.
If the waste toner bottle is not correctly
installed or the transfer belt release lever is
at its top position (11 o’clock), the front
door cannot be closed.
"#
The printer must complete a 150-second calibration cycle after any
consumable has been replaced. If you open the door before the
message window reads
IDLE/MAGICOLOR 2300DL , the printer
stops and repeats the calibration cycle.
$ $ $ $
% % % %
$ $ $ $
$ $ $ $