Konica Minolta MAGICOLOR 2300 - Manual (Page 108)

Solving Other Problems 98
Printing
takes too
much time. The printer is set to a
slow printing mode
(for example, thick
stock or
transparency). It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
The printer is set to
power saving mode. It takes time for printing to start in
power saving mode. If you do not want
to use this mode, disable it.
The job is very
complex. Wait. No action needed.
The printer memory is
insufficient. Add more memory.
Blank pages
come out
during a
printing job. One or more of the
toner cartridges are
defective or empty. Check the toner cartridges. The image
does not print if the cartridges are
empty.
The wrong media is
being used. Check that the media type set in the
driver matches the media loaded in the
printer.
Printer
returned to
IDLE before
the menu
was
changed.
The printer was in the
menu structure
without a selection
being made within
two minutes. When in the menu structure, select
your choice before two minutes elapse.
Not all pages
print. The printer has the
wrong kind of cable,
or the printer is not
configured for the
correct cable and
port. Check your cable.
The Cancel key was
pressed. Make sure no one pressed the Cancel
key while your job was printing.
The media tray is
empty. Check that the media trays are loaded
with media, in place, and secure.
A document is printed
with an overlay file
which has been
created by a
non-magicolor 2300
DL driver. Print the overlay file using a magicolor
2300 DL driver from the magicolor
2300 DL Utilities and Documentation
CD-ROM.
Symptom Cause Solution