Konica Minolta MAGICOLOR 2300 - Manual (Page 159)

Interface Panel 149
WARNING!
Obstructing the ventilation grilles could present a fire hazard.
! Do not tilt the printer more than 1° when moving it.
! If the printer is located in a cold room that is rapidly heated, or if the printer
is moved from a cold place to a warm, humid place, condensation may
occur within the printer, degrading print quality. If this occurs, allow the
printer to adapt to the environment for about one hour before use.
! If using a humidifier or water vaporizer in the room with the printer, use
only purified or distilled water. Impurities in the water may be released into
the air, where they can accumulate inside the printer and cause degraded
printer output.
Attention
For products installed outside North America, do not connect the
groundwire to gas or water pipes or grounding for telephones.
Interface Panel
$ $ $ $ Ethernet Port
Use a twisted-pair (RJ45) Ethernet cable when connecting the Ethernet port
on the printer to a 10BaseT/100BaseTX network connection.
% % % % USB (version 1.1) Port
Use a USB cable (Type B) when connecting the USB port on the printer to the
USB port on your computer.
& & & & Parallel Port
Use a Centronics IEEE 1284 bidirectional parallel cable when connecting the
parallel port on the printer to the parallel port on your computer.