Konica Minolta MAGICOLOR 2300 - Manual (Page 74)

Replacing Consumables 64
2
Open the printer’s front door.
3
Remove the toner cartridge.
4
Remove the protective cover from the new toner cartridge and insert the
cartridge into the carousel.
5
Close the printer’s front door.
For details on replacing the toner cartridge, refer to steps 2 through 14 of
“When the message
REPLACE TONER appears”.
"#
The printer must complete a 150-second calibration cycle after any
consumable has been replaced. If you open the door before the
message window reads
IDLE/MAGICOLOR 2300DL , the printer
stops and repeats the calibration cycle.
Replacing the Waste Toner Bottle
When the waste toner bottle becomes full, the message WASTE TONER BOX
FULL appears. The printer will stop and will not start again until the waste
toner bottle is replaced.
Removing the Used Waste Toner Bottle
1
Open the printer’s front door.
2
Grasp the waste toner bottle’s handle and
lift it up, and then carefully remove the
waste toner bottle.
Keep the waste toner bottle upright so the
toner does not spill.
3
Remove the two caps by turning them
counterclockwise.