Konica Minolta MAGICOLOR 2300 User Manual

Page 70

Replacing Consumables

Support the middle of the cartridge
with your left hand, insert the thumb
and index finger of your right hand into
the two holes in the front of the toner
cartridge, and then insert the cartridge
so that the guides on the cartridge fit
into the rails in the cartridge
compartment in the carousel.

Gently push the new toner cartridge
into the printer.

Close the printer’s front door.

The printer must complete a 150-second calibration cycle after any
consumable has been replaced. If you open the door before the
message window reads

IDLE/MAGICOLOR

2300DL

, the printer

stops and repeats the calibration cycle.

If the toner cartridge was checked in step 5 and found to have the
KONICA MINOLTA brand, this completes the replacement procedure.
If a MINOLTA-QMS toner cartridge is being installed, continue with the
following operation to specify the volume of the toner cartridge.

Press Key

(Until) Message Window Reads

IDLE

MAGICOLOR 2300DL

LANGUAGE

ENGINE

CHANGE TONER SZ

BLACK

CHANGE TONER SZ

Color

HIGH CAPACITY